Arduino GSM Expandable Vehicle Connection Project


Working late last night, I managed to figure out got to take apart my seat covers and insert my capacitance sensor.

Oh ya also, note to future self, don’t use 10 awg ground wire … I had to change all the wire routing in my car because it was to hard to work with.

I’ve also placed my Arduino in a protective case. Attached behind my rear view mirror with Velcro.

I’ve t-tapped into my constant-on 12v line from my ceiling light. This way I can have my vehicle constantly monitoring. I’ll be purchasing a lithium battery booster today until I can assess the power used by my system … I also haven’t setup any safeguards against battery drain in my code yet … I’ll have to look into that.

Today, I have school. So tomorrow I’ll have to go to Lee’s again to get a new LCD display. I would have had this done by now but my first one burnt out during the original accidental short (read: blowup). Also, when I bought my second one I didn’t read that it was for the raspberry pi.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s